Safety Considerations - Casablanca Twain Owner's Manual

Twain
™

Safety Considerations

Safety and the proper operation of your Casablanca
fan both require a thorough knowledge of the
product and proper installation; therefore, before
attempting to install and operate your Casablanca
fan, read this Owner's Manual completely and
carefully. Retain this manual for future reference.
Ñ
CAUTION:
RISK OF ELECTRICAL SHOCK!
Turn off all electricity at the circuit breaker
or fuse box before attempting any
installation procedure. Installation is to be
in accordance with the National Electrical
ANSI/NFPA 70-1999 and local codes. If
you are unfamiliar with the wiring codes,
contact a qualified electrician. To avoid
overheating and possible damage to
other equipment, do not install control
to a receptacle, fluorescent light fixture,
operating appliance, or transformer-
supplied appliance.
• This ceiling fan requires a grounded electrical supply
of 120 VAC, 60 Hz and a minimum of 15-amp
circuit. The maximum current required for the fan
with light fixture is 3.2 amps (382 watts). The fan
uses about 1.1 amps (132 watts). Maximum light
current is about 2.1 amps (190 watts) of lighting.
• Where wire nuts are employed, be sure all
bare wires are fully inserted into the metal wire
connectors inside the plastic wire nut covering.
• When installing the canopy, light kit, and wall
controls, make sure all wires are carefully
tucked away and that no wires are pinched.
• The fan must be supplied with three
independent 120V AC supply wires to provide
power for the fan, the light, and neutral.
Ñ
WARNING:
To reduce the risk of
personal injury or damage to the fan,
do not bend the blade brackets or insert
foreign objects in between the rotating fan
blades.
Ñ
WARNING:
To reduce the risk of fire or
electric shock, do not use this fan with any
solid-state control device. Use only the
control provided with or recommended for
this fan.
6
Fuse Box
(Remove fuse for the
circuit you will be
working on)
from wall to
end of blade
18" �
70" �
from wall to
center of fan
Dimensions indicated are the minimum
allowable for proper installation.
Circuit Breaker
(Trip breaker for the
circuit you will be
working on)
from bottom edge
84" �
of blade to floor