• The electrical cable is secured to outlet box by an approved connector . • Six inches of lead wires extend from outlet box . If your existing fan site is suitable, skip ahead to Section 2 • Installing the Ceiling Plate. M6000-01 • 08/22/14 • Casablanca Fan Company...
Page 4
Section 2 • Installing the electrical codes and ANSI/NFPA 70 . If Ceiling Bracket. you are unfamiliar with wiring, use a qualified electrician . M6000-01 • 08/22/14 • Casablanca Fan Company...
Page 5
Support Brace instructions, and use only the hardware supplied . Ceiling Outlet Box Angled Mounting Style Angled Mounting recommended for a vaulted or angled ceiling . M6000-01 • 08/22/14 • Casablanca Fan Company...
WARNING! To avoid possible electrical shock, make certain multiple remote-controlled fans?” that electricity is turned off at the circuit breaker or fuse box for more information . before attempting any installation or repair procedure. M6000-01 • 08/22/14 • Casablanca Fan Company...
. 2-5 . Tighten the screws into the 9/64” pilot holes; do not use lubricants Steps 2-3 – 2-5 on the screws . Do not over tighten . Flat Washer 3” Wood Screw M6000-01 • 08/22/14 • Casablanca Fan Company...
8” extending from the top of the downrod . opening toward peak 3-6 . Raise the fan and place the downrod ball into the ceiling bracket . Ceiling Bracket Downrod Step 3-6 M6000-01 • 08/22/14 • Casablanca Fan Company...
• The white wire from the fan to the white wire from the receiver (marked on white tag “COMMON OUT”) Wire Connector Note: The red wire from the receiver will not be used . It has a pre- installed wire terminator . Step 4-4 M6000-01 • 08/22/14 • Casablanca Fan Company...
Blade Mounting Do not use a furniture polish or any other cleaners Screw that leave any residue, as they will damage the protective Dust Armor on the blades . Steps 6-3 - 6-4 M6000-01 • 08/22/14 • Casablanca Fan Company...
7-7 . Use the optional switch housing cap to attach light kits that mount using a center stem attachment . Follow the instructions included with the light kit for the wiring, mounting, and assembly . Step 7-7 M6000-01 • 08/22/14 • Casablanca Fan Company...
Steps 8-11 control must be grounded using the attached green wire . If not placed in an outlet box, cap the green wire coming from the wall control with an included wire nut . M6000-01 • 08/22/14 • Casablanca Fan Company...
Safe-Exit Mode. 2. The lights will flash for visual confirmation. 3. The lights will stay on 100% brightness for 30 seconds. After a total of 30 seconds, the lights will turn off. M6000-01 • 08/22/14 • Casablanca Fan Company...
Your fan automatically detects what type of bulbs that are installed WARNING! each time it is powered up. NOTE: If CFL bulbs are detected, the dimming function will automatically be disabled. Remember to turn off the lights before replacing bulbs. Figure 4 M6000-01 • 08/22/14 • Casablanca Fan Company...
7130 Goodlett Farms Pkwy . #400 Memphis, Tennessee 38016 AUTHORIZED SERVICE CENTERS For the most updated listing of Casablanca Authorized Service Centers, visit www . C asablancaFanCo . c om/servicecenters or call toll free 1-888-227-2178 . M6000-01 • 08/22/14 • Casablanca Fan Company...
Page 17
. Ceiling fan models bearing the ENERGY STAR label move air 14 - 20% more efficiently than typical ceiling fan models . For more information on ENERGY STAR visit www . e nergystar . g ov . M6000-01 • 08/22/14 • Casablanca Fan Company...