Table of Contents
Advertisement
Twain
™
5
Fasten one of the two wall plates (white or ivory)
to the wall control using the two wall plate screws.
6
Set the fan speed to HIGH on the wall control.
Return power to the panel and test the controller.
Ñ
CAUTION:
Failure to set the fan speed to
HIGH can result in faulty operation of the
fan and damage to the wall control.
Operating the W-81 Wall Control
•
Turn the upper knob to the desired fan speed.
•
Turn the lower knob to the desired light setting.
Attaching the Canopy Hatch
7
Tuck the wires into the canopy with the wire nuts
pointed toward the ceiling. Place the BLACK and WHITE/
GREEN wires on opposite sides of the canopy. All wires
should be clear of the canopy opening. Tilt the motor
housing and downrod to install the canopy hatch.
8
Use the last remaining canopy screw and
lock washer to secure the canopy hatch. Straighten
the fan and ensure all parts are tightly secured.
Check for movement at the following joints:
•
Between the canopy and the ceiling
•
Between the canopy and the
downrod and ball assembly
16
STEP 5
Wall plate
screws (2)
STEPS 7-8
Canopy hatch
Canopy screw
and washer
NO DRILL
Canopy
Advertisement
Table of Contents
