Changing Frequency Setting; Automatic Demonstration Program - Casablanca Bel Air Instructions Manual

NOTE: All fans leave the factory set to
"1111"
You will only have to change the dip switch settings in the remote if you are using
more than one fan in the same area and want to control them separately.
Step 1. Turn power OFF at the circuit breaker or fuse box and at the toggle switch,
for the fan you want to change.
NOTE: DO NOT set dip switch setting in the remote
to '0000', this may cause frequency interference from
other Casablanca Products.
Step 2. Remove the screws and switch plate from the existing switch box.
Step 3. Remove the screws holding the switch in the switch box.
Step 4. Pull the existing W-85 switch from the switch box to expose the dip switches
located on the side of the control as shown in Figure #1.
Step 5. Change the dip switch settings, assuring that they are different from the
previously installed Inteli-Touch
Step 6. Mount the W-85 Wall Control unit back into the wall electrical box.
Step 7. At the circuit breaker or fuse box and at the toggle switch, turn the power off
for the fan whose frequency you are changing.
Step 8. Within 20 seconds of restoring power to the ceiling fan and the W-85 Wall
Control press and hold both the "FAN" and "REVERSE" buttons as shown in Figure
#2 for 3 seconds, you will hear one tone from the Piezo Buzzer indicating the com-
mand has been accepted.

AUTOMATIC DEMONSTRATION PROGRAM

Programmed into every Inteli-Touch
Automatic Demonstration Program. It can be used to fully
demonstrate and test the operation of the fan.
To enter the demonstration program:
1. Turn off for at least 5 seconds. This will clear the
fan memory ready for programming.
2. Turn on.
3. Immediately operate the buttons in the following sequence:
A multi-tone signal will verify the start of the test program
which proceeds as follows:
+
+
3
®

CHANGING FREQUENCY SETTING

3 fan.
®
3 Series fan is an
®
+ +
DIP
SWITCHES
DIP SWITCHES
SET TO '1111'
(Factory Setting)
• Lights slowly increase to full intensity.
• Fan accelerates to speed three with audio tones.
• Light dims to half intensity.
• Fan accelerates to full speed with audio tones.
• Fan reverses at full speed with audio tones.
• Fan operates at full speed.
• Fan turns off with audio tones (blades coast for a short time).
• Lights turn off.
The complete cycle lasts slightly over one minute. It will
continue to repeat until the
than five seconds, cancelling the program.
DIP SWITCHES
SET TO '1001'
is turned off for more
13