Table of Contents
Advertisement
1
2
0
4
3
1
2
0
The
power button is normally left in the on position. Always turn the
power off during cleaning or servicing the fan and during thunderstorms. It
4
3
is also used to exit or enter additional programs.
The
power button must be left on to retain a previously set fan speed
or light level.
There are five individual speed settings for the fan. Each speed is
indicated by the number on the controller and an audible tone for
each speed.
To select the desired fan speed:
Press the number on the controller corresponding to the speed
desired. 4 is high, 3 medium, 2 low, 1 ultra-low, and 0 is off.
The direction of airflow can be changed from downward to upward
or from upward to downward.
1
2
0
To reverse the airflow:
4
3
1. Make sure the fan is on and blades are turning.
2. Press the
reverse button. You will hear a series of clicks
from the fan as it speeds up before coming to a stop and
changing direction.
To turn the lights off and on, press and release the
either the up or down lights for less than one second.
To dim either the up or down light, Press and hold the
for either the up or down light for more than 1 second. The light will
come on at the last brightness setting and increase in brightness
until full power is reached, then start dimming until the lowest
setting is reached. This cycle will repeat until you release the light
button.
W-74 oPeRation
oPeratIon Power
oPeratIon sPeed ControL
oPeratIon reversIng aIrfLow
oPeratIon LIgHts
1
4
direct - touch
Note: It is normal for the fan
to start in the "High" position
from "Off" before changing to
the selected speed.
button for
2
0
button
3
1
2
0
Note: The dimming feature
will only work as long as the
4
3
dimming feature remains
active. See "Operation CFL
mode".
1
2
0
4
3
1
2
0
4
3
1
2
0
4
3
1
2
0
4
3
Up Light
Down Light
1
2
0
4
3
19
Advertisement
Table of Contents
