Canopy Electrical Connections; Canopy Hatch Installation - Casablanca Holliston C31UxxZ Owner's Manual

canopY electrIcal connectIonS

Step 7. Attach the fan wires to the ceiling fixture outlet box
wiring by placing the bare ends of the wires side by side
and then securing with a wire nut. test that the connection
is secure by pulling on the wire nut. Connect in this order:
• GReen leads from mounting plate and downrod assembly
of fan to GRound conductor of power source. Secure
with wire nut.
• White wire from fan to white neutRaL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLaCk power wire from fan to BLaCk power wire in
ceiling outlet box. Secure with wire nut.
note: If the color of your ceiling wires differs from that
described, consult an electrician.
canopY HatcH and cover rInG InStallatIon
Step 8a. tuck the wires into the canopy with the
wire nuts pointed upwards, so that the White and
BLaCk wires are on opposite sides of the canopy
and all wires are clear of the canopy opening.
Step 8b. Install the canopy hatch with the last
canopy screw and lock washer using the provided
screwdriver. to do this, tilt the fan body away from
the hatch opening. Tighten the screws firmly.
Step 8c. Straighten the fan, then check to ensure
there is no movement between the canopy and the
ceiling or the Perma•Lock
assembly.
Step 8d. locate the locking pins
on the canopy cover ring as shown
in Figure #2. lift up on the canopy
cover ring and guide the two (2)
locking pins into the two (2) locking
holes, then snap the canopy cover in
to place as shown in Figure #3.
12
downrod and the ball
™
LOCKING
HOLES
WIRE NUT
2 BLACK WIRES
2 WHITE WIRES
3 GREEN WIRES
CANOPY
HATCH
CANOPY
SCREW &
WASHER
Figure #1
CANOPY
COVER
RING
LOCKING PINS
Figure #2
CANOPY
Figure #3