Casablanca Holliston C31UxxZ Owner's Manual page 17

SwItcH HoUSInG and end cap InStallatIon
No LIGHT kIT
- Installation:
NOTE: If you are installing your fan without a light
kit attached as shown in Figure #1, continue with these
installation instruction
Figure #1
SWitCh houSinG haRdWaRe (not to scale)
Light kit adaptor assembly
Step 11a. locate the light kit adaptor assembly and
screw plug as shown in the switch housing hardware
section above. You will need to install the complete
assembly for no light kit installation.
note: do not discard screws during
disassembly, all screws will be needed
for other installation steps within this
document.
Light kit adaptor disassembly
Step 11b. locate and remove the one #8-32
screw that is attaching the bottom cap to the light
kit adaptor assembly as shown in Figure #2 and
remove the bottom cap. do not discard screws during
disassembly.
Step 11c. locate and remove the four #6-32 screws
from the cap and remove the cap. do not discard the
screws during disassembly.
NOTE: Locate the light kit adaptor as shown in Figure #2,
this adaptor plate will need to be attached to the fan during
fan installation for light kit or no light kit installation.
SCReW PLuG
BottoM CaP
LIGHT kIT
SCReW , #8-32
Screw Plug
BottoM CaP
Cap SCReW,
H
olliston
CaP
PLate
Figure #2
BottoM CaP
Figure #3
CaP
#6-32
Figure #4
™
SCReW
#8-32
SCReW
#6-32
15