Changing The Size And Orientation Of Paper In The Trays; Changing The Size And Orientation Of Paper In Tray 1 - Xerox WorkCentre 5020 User Manual

Changing the Size and Orientation of Paper in the Trays

This section describes how to replace paper in the trays with a different size and
orientation of paper, and how to specify the size and orientation of paper.
Note

Changing the Size and Orientation of Paper in Tray 1

The following procedure describes how to change the size and orientation of paper in
Tray 1.
1.
Pull out Tray 1 towards you.
Note
2.
Remove the remaining paper.
3.
Push down the metal plate to the
bottom of the tray.
4.
Slide paper guides towards the front
and back of the tray.
Xerox WorkCentre 5016/5020 User Guide
Changing the Size and Orientation of Paper in the Trays
• When using non-standard size paper for a print job, load the paper in the Bypass Tray.
You must register the paper size in the print driver in advance.
For information on how to specify a custom paper size in the print driver, refer to
"Specifying the Custom Paper Size" (P.79).
• While the machine processes a
job, do not pull out the tray in use.
46