Xerox WorkCentre 5020 User Manual page 17

No. Component
2 Bypass Tray
3 Extension Flap
4 Access Cover 1
5 Access Cover 2
6 Document Feeder
7 Control Panel
8 Output Tray
9 Front Cover
10 Left Side Cover Latch
11 Tray 1
12 Paper Tray 2 (optional)
13 Stand (optional)
14 USB Interface Connector
15 Power Cord Connector
16 Power Switch
Xerox WorkCentre 5016/5020 User Guide
Load standard size paper and non-standard size paper. It holds special
media such as thick stock paper or other special media that cannot be
loaded in Tray 1 or Tray 2.
For more information on the supported paper types and capacity of the Bypass
Tray, refer to "Supported Paper Sizes and Types" (P.40).
Supports paper that is loaded in the Bypass Tray. Slide out this flap
before loading paper in the Bypass Tray.
Open this cover to remove paper jams in and around Tray 1 and Tray 2.
For more information on how to clear paper jams, refer to "Paper Jams"
(P.102).
Open this cover to remove paper jams in and around Tray 2.
Note • The Access Cover 2 is a part of the optional Paper Tray 2.
For more information on how to clear paper jams, refer to "Paper Jams"
(P.102).
Automatically feeds documents that are loaded to be scanned for a copy
or a scan job.
Note • The Document Feeder may not be fitted depending on the machine
model in use.
Consists of the Display, the Machine Diagram (mimic), buttons and
indicators.
For more information on the Control Panel, refer to "Control Panel" (P.20).
Copies and prints are delivered here, face down.
Open this cover to replace the Drum Cartridge and to add toner.
Pull up this latch to open the Left Side Cover.
Load standard size paper. It holds up to 250 sheets of plain paper.
For more information on supported paper types and tray capacity, refer to
"Supported Paper Sizes and Types" (P.40).
Adds an additional tray that can be used as Tray 2. Load standard size
paper. It holds up to 500 sheets of plain paper.
Note • Paper Tray 2 is an optional accessory.
For more information on supported paper types and tray capacity, refer to
"Supported Paper Sizes and Types" (P.40).
Elevates and stabilizes the machine for optimum use. The attached
casters allow you to move the machine easily.
Note • The stand is an optional accessory.
Connects the USB cable to the machine.
Connects the power cord to the machine.
Switches the power to the machine on and off.
Machine Components
Function
17