Installing An Eisa, Pci Or Graphics Board - HP 2240 Owner's Manual

Installing an
EISA, PCI or
Graphics Board
Your J282 workstation's EISA Assembly has five slots. Four are
EISA slots; of these, two are EISA-only and two are EISA/GSC slots.
The bottom slot is GSC only.
Your J2240 workstation's PCI Assembly has five slots. All five slots
support PCI cards. Three slots support 32–bit PCI and two support
64–bit PCI. Two of the 64–bit slots and one of the 32–bit slots sup-
port GSC. Slot 4 also optionally supports EISA.
NOTICE: The 32–bit PCI slots expect 5.0V signalling,
while the 64–bit PCI slots expect 3.3V signal-
ling
The graphics boards supported by your workstation provide:
HP VISUALIZE EG- Fast 2D graphics
HP VISUALIZE-8/24 Accelerated 8-plane or 24-plane
graphics
HP VISUALIZE-48 24/24 Image plane, 24–bit Z buffer,3D
graphics
HP VISUALIZE–FX2, –FX4, –FX6 (J2240 only)
NOTICE: Dual graphics boards take up two slots. Other
graphics boards may take one, two or three
slots.
Figures B–31, B–32 and B–33 show the physical layout of the EISA/
GSC slots, first from outside the system unit, then from inside the PCI
and EISA Assemblies.
B-51