Cabletron Systems CSX200 User Manual page 85

2. To change the State, click on the selection box and a pull down menu will
3. To change the Polling Interval, highlight the current value in the text box, type
4. To change the Full Enquiry Interval, highlight the current value in the text
5. To change the Error Threshold, highlight the current value in the text box,
6. To change the Monitored Events, highlight the current value in the text box,
7. To change the Max Virtual Circuits, highlight the current value in the text box,
8. Click on
Configuring the Frame Relay Protocol
b. Choose All Interfaces to apply changes to all WAN interfaces on the
device that are configured for Frame Relay.
appear. Select either ansiT1-617-D or noLmiConfigured, and release the
mouse button. The new configuration will appear in the text box.
a new value (from 5-30 seconds) in the text box, and press Enter/Return.
box, type a new value (from 1-255) for the number of successive intervals that
must pass before a Full Enquiry message is sent, and press Enter/Return.
type in a new value (from 1-10) for unanswered status enquiries that must
pass before the interface is declared to be down, and press Enter/Return.
type a new value (from 1-10) for the number of status polling intervals over
which the error threshold is counted, and press Enter/Return.
type a new value (between 1 and 4 on a CSX200 device, between 1 and 32
for each interface on a CSX400) in the text box, and press Enter/Return.
to save the changes or
configuration.
CSX WAN Configuration
to restore the original
4-21