Cabletron Systems CSX200 User Manual page 66

CSX WAN Configuration
from the command line (stand-alone mode)
1. From the appropriate directory type:
The spmarun script invoked Þrst in the above command temporarily sets the environment
variables SPMA needs to operate; be sure to use this command any time you launch an
NOTES
application from the command line. This script is automatically invoked when you launch
the application from the icon menu.
If you wish to change the conÞguration, be sure to use a community name with at least
Read/Write access. If you only wish to view current settings, a community name with
Read access will be sufÞcient.
If there is a hostname mapped to your CSXÕs IP address, you can use <hostname> in place
of <IP address> to launch this application. Please note, however, that the hostname is not
the same as the device name which can be assigned via Local Management and/or SPMA;
you cannot use the device name in place of the IP address.
The WAN ConÞguration window will appear.
ConÞguration window for a CSX400 that has two WPIM-T1s installed.
4-2
spmarun wancon <IP address> <community name>
Figure 4-1
Accessing the CSX WAN Configuration Window
shows a WAN