Salus ST620RF Instruction Manual page 10

ST620RF Manual Version 005 CMYK:Layout 1
After selecting the PAIR Menu, PAIR and the RF icon are displayed.
The unit counts down for a period of 10 minutes, with the RF Signal indicator flashing while the signal is being
transmitted. The RF address code will be generated randomly and the Control Centre will transmit the signal every
second for the full 10 minutes until:
• The Arrow key is pressed to return to the previous display
• The OK key is pressed to return to NORMAL mode
• The 10 minute timer runs out
Note that the Receiver must be already in learning mode BEFORE attempting to access the PAIR menu on the Control
Centre. If the Red SYNC LED has not turned off after 10 minutes, repeat the whole pairing process.
Pressing the Reset button on the Control Centre and the Receiver will clear the RF address code and generate a new
default code which will be saved into the internal memory of the unit; there is no need to re-pair the Receiver and
Control Centre. This is a quick and easy way to directly link the units in many applications.
10
Press the OK key to start sending the RF address code to the Receiver.
The ST620RF Control Centre display will change to show a rundown timer:
1/9/10 11:56 Page 10
ST620RF INSTRUCTION MANUAL