Table of Contents
Advertisement
G
Connection Errors
The following are errors that occur during or after connection to the camera server. The
error messages are displayed in the viewer image display area.
Message
Could not connect to the image server.
Cause
Connection to the camera server failed.
Check that the description of the image distribution website is correct and that the
Solution
camera server is connected to the network correctly.
Message
The network is currently busy. Please wait a few moments and then connect again.
Cause
The number of permitted camera server connections was exceeded.
Too many people are trying to access the camera server. Wait a few moments and then
Solution
try again. Check also whether the permitted number of concurrent accesses to the
camera server is very small.
Message
Could not join the queue for control privileges.
Cause
The limit on the number of users queuing for control privileges has been exceeded.
Too many people are trying to access the camera server. Wait a few moments and
Solution
then try again.
Message
Connection to the image server is restricted.
The limit set on the camera server for the number of clients that can be connected
Cause
has been exceeded.
Specify additional settings on the camera server so that the server can be accessed
Solution
by WebView Livescope MV clients.
Message
The camera is switched off or is faulty.
Cause
The connected camera is switched off or the RS-232C cable is not connected
correctly.
Check that the camera server is switched on and that the RS-232C cable is
Solution
connected correctly.
Message
The connection was cut.
Cause
The connection time limit expired.
Solution
Connect again.
Error Messages
69
Advertisement
Table of Contents
