For Windows 98/Me; Installing From Cd-Rom Setup - Canon LASER SHOT LBP3210 User Manual

For Windows 98/Me

The screen shots used in this section are from Windows Me.

Installing from CD-ROM Setup

1
Make sure that the printer is turned OFF and the computer
and printer are not connected with a USB cable.
IMPORTANT
•
Connect the USB cable at the appropriate point (Step 10 on p. 3-7) during the
installation, and then turn the power ON.
•
If a Wizard appears by the Plug and Play automatic setup, click [Cancel], and then
install the CAPT software using this procedure.
2
Turn the power of the computer on and start up Windows 98/
Me.
3
Insert the supplied "LBP3210 User Software" CD-ROM into
the CD-ROM drive.
If the CD-ROM is already set in the drive, take it out and insert it into the drive
again.
CD-ROM Setup appears automatically.
IMPORTANT
If CD-ROM Setup does not appear automatically, select [Run] from the [Start]
menu, enter "D:\English\CNAB2MNU.exe", and then click [OK]. (The CD-ROM
drive name is indicated as "D:" in this manual. The CD-ROM drive name may differ
depending on the computer being used.)
4
Click [Install].
The dialog box for confirming the language is displayed.
5
Confirm the language and click [Yes].
After the preparation for installation is completed, the CAPT (Canon Advanced
Printing Technology) software installer starts up, and the [Setup Wizard] dialog
box appears.
Installing the CAPT Software
3
3-5