Canon LASER SHOT LBP3210 User Manual page 247

Cause 2
Remedy
A portion of a page is not printed.
Cause 1
Remedy 1 Remove the checkmark from [Manual Scaling] in the printer driver. If you
Remedy 2 Place a checkmark for [Manual Scaling] in the printer driver and specify an
Cause 2
6
Remedy
Cause 3
Remedy
Front or back of the printouts is stained with black dots.
Cause
Remedy
Print position is misaligned.
Cause
Remedy
6-20 Print Quality Problems
The printer is exposed to direct sunlight or strong light.
Move the printer to a place where it will not be exposed to direct sunlight or
strong light. Alternatively, move the strong light source away from the printer.
The scale factor is incorrect.
remove the checkmark, the scale factor will be set according to [Page Size] and
[Output Size] automatically.
In order to specify the setting for [Manual Scaling], open the [Page Setup]
sheet.
appropriate scale factor according to the paper size to be used.
In order to specify the setting for [Manual Scaling], open the [Page Setup]
sheet.
The position of the paper is incorrect.
Load the paper properly. (See "Printing on Plain Paper/Heavy Paper/Label/
Transparency," on p. 2-15; "Printing Envelopes," on p. 2-29; "Printing on Custom
(Nonstandard) Paper Size," on p. 2-43)
A document with no margins was printed.
The printable area of this printer is an area excluding 5 mm from the upper,
bottom, right, and left of the paper sides. Therefore, you should secure a margin
of 5 mm or more around the print data.
The fixing unit is dirty.
Perform the cleaning operation. (See "Cleaning," on p. 5-12)
"Top Margin" and "Paper Position" in the application are not specified properly.
Specify the settings for "Top Margin" and "Paper Position" in the application
properly. (See the instruction manual supplied with your application)