HP BL20p - ProLiant - G2 Setup And Installation Manual page 41

Installing System Hardware
3. Slide the interconnect into the server blade enclosure interconnect bay (1).
4. Close the ejector levers (2).
5. Repeat steps 1 through 4 for the second interconnect.
Figure 3-12: Installing an interconnect (RJ-45 patch
panel shown)
If you installed interconnect switches, you must configure them with the appropriate
software utilities. For more information, refer to the documentation that ships with
the interconnect switch.
HP ProLiant BL p-Class System Setup and Installation Guide 3-15