System Features; Minimum Hardware Requirements - HP BL20p - ProLiant - G2 Setup And Installation Manual

The HP ProLiant BL p-Class system offers a range of power and performance for
large-volume rollouts in space-constrained environments. The ProLiant BL p-Class
system architecture is a revolutionary step in server modularity that stresses rapid
deployment and remote management.

Minimum Hardware Requirements

To set up the system, you must choose and install several of the modular
components. The following hardware components are required to operate a
ProLiant BL p-Class system. For specific features and supported configurations, refer
to the system QuickSpecs or the ProLiant BL p-Class System Overview and Planning
white paper.
•
One ProLiant BL p-Class server blade
•
One ProLiant BL p-Class server blade enclosure
•
One pair of interconnects
•
One single-phase or three-phase ProLiant BL p-Class power enclosure with hot-
plug power supplies, if using AC power—or—one facility DC cable kit, if using
your own DC power
•
One pair of power distribution devices (bus bars or power bus box)
•
One Compaq branded, telco, or third-party rack cabinet
NOTE: For third-party rack cabinet requirements, refer to the "Rack Requirements" section in
Chapter 2, "Planning the Installation."
HP ProLiant BL p-Class System Setup and Installation Guide

System Features

1
1-1