Portcfg Command; Srcfg Command - Lenovo RD220 - ThinkServer - 3798 User Manual

ok
system> passwordcfg
Security Level: Customize
-exp: 365
-cnt: 5
-nul: allowed

portcfg command

Syntax
portcfg [options]
portcfg [options]
options:
-b baud_rate
-climode cli_mode
-cliauth cli_auth
Description
Use the portcfg command to configure the serial port. To change the serial port
configuration, type the options, followed by the values. To change the serial port
configuration, you must have at least Adapter Networking and Security
Configuration authority.
The parameters are set in the hardware and cannot be changed:
v 8 data bits
v no parity
v 1 stop bit
The following table shows the arguments for the options.
Option Description
-b Baud rate
-climode CLI mode
Example
system> portcfg
-b : 115200
-climode : 2 (CLI with user defined keystroke sequences) system>
system>

srcfg command

Syntax
srcfg [options]
options:
-exitcliseq exitcli_keyseq
Description
Use the srcfg command to configure the serial redirection. Type srcfg to display
the current configuration. To change the serial redirect configuration, type the
Values
9600, 19200, 38400, 57600, 115200, 230400
none, cliems, cliuser
v none: The command-line interface is disabled.
v cliems: The command-line interface is enabled
with EMS-compatible keystroke sequences.
v cliuser: The command-line interface is enabled
with user-defined keystroke sequences.
Chapter 7. Command-line interface
87