Table of Contents
Advertisement
ULTRA2 LVD SCSI HOST ADAPTER
5.6.1 N
OS/2 I
EW
NSTALLATION
These instructions will guide you through installing both OS/2 itself and the
Ultra2 LVD SCSI Host Adapter's OS/2 device driver at the same time. The OS/2
operating system can be installed from floppy diskettes or from CD-ROM. The
Adapter's OS/2 driver is on Driver Disk 1. It is important that the Adapter
hardware has been installed successfully before proceeding further.
1. Make a backup copy of OS/2 Diskette 1 using a blank diskette and label it
something like "OS/2 Diskette 1 for SCSI Adapter".
2. Copy the "\OS2\INIA100.ADD" file from Driver Disk 1 to the root directory on
the "OS/2 Diskette 1 for SCSI Adapter" you just made.
3. Using an appropriate text editor, modify the CONFIG.SYS file on the "OS/2
Diskette 1 for SCSI Adapter" by adding these lines for the Adapter driver at
some point after the "SET OS2_SHELL=CDINT.EXE" line:
BASEDEV=INIA100.ADD
SET COPYFROMFLOPPY=1
Once you've added thes lines, save the file.
4. Insert the Installation Diskette—this is another one of the operating system
diskettes—into drive A: and turn on your computer. This will begin the OS/2
installation and establish an OS/2 bootable hard drive.
5. When prompted, insert the "OS/2 Diskette 1 for SCSI Adapter". Follow the
on-screen instructions to continue.
6. This completes the Adapter's device-driver installation for OS/2. Follow the
on-screen instructions to finish your OS/2 installation; also refer to your
OS/2 manual for a complete description of installation procedures.
68
Advertisement
Table of Contents
