Table of Contents
Advertisement
5.3.2 A
W
DDING THE
These instructions will guide you through the installation of the Ultra2 LVD SCSI
Host Adapter's Windows 98 driver in an existing Windows 98 system. Windows 98
will automatically detect the presence of new hardware in Plug-and-Play compliant
systems. It is important that the Adapter hardware has been properly installed
before proceeding further.
1. Reboot the system. Microsoft Windows 98 will detect the presence of new
hardware at bootup and will display a dialog window titled "New Hardware
Found," which will have "PCI SCSI Bus Controllers" highlighted.
2. Select "Driver from Disk Provided by Hardware Manufacturer," then click on
"OK.".
3. Select "SCSI Controller" from the list of available devices, then select "Have
Disk...".
4. An "Install from Disk" window will appear. Insert Driver Disk 1 into drive A:,
then enter the pathname of the Windows 98 driver's directory ("A:\WIN95")
and select "OK."
5. Select "Initio INI-A100U2W PCI SCSI Controller", then select "OK", then
"OK" again to install the INIA100.INF driver on your hard disk drive.
(Because of a Windows quirk, the A:\WIN95 directory might become
deselected; it might be necessary to direct Windows back to A:\WIN95—
possibly several times—before it actually copies the driver.)
6. This completes installing the Adapter's device driver. Reboot the system to
activate the driver.
7. We highly recommend that you verify that your Windows 98 device driver has
been properly installed by starting at the desktop and selecting these items
one after the other (each item contains the next in sequence): "My
Computer," "Control Panel," "System," "Device Manager" tab, "SCSI
Controllers" category, "Initio INI-A100U2W PCI SCSI Controller." If "This
device is working properly" is displayed on your screen, the driver has been
correctly installed.
98 D
INDOWS
RIVER TO AN
CHAPTER 5: Driver Installation
E
W
XISTING
INDOWS
98 S
YSTEM
53
Advertisement
Table of Contents
