Table of Contents
Advertisement
ULTRA2 LVD SCSI HOST ADAPTER
5.4.3 D
N
ISKLESS
EW
For computer systems installing or upgrading to Windows NT using a diskless
method such as network downloading, these instructions will guide you through
the Ultra2 LVD SCSI Host Adapter's Windows NT driver installation. The
Windows NT driver is on Driver Disk 1. It is important that the hardware has been
installed successfully before proceeding further.
Even though Windows NT can be installed across a network, you must
use a floppy drive on the local host computer to install the Adapter's
Windows NT driver on that computer.
1. Execute a diskless setup as described by the Windows NT System Administrator's
Guide.
2. When SETUP begins to load, the screen will turn from black to blue, and the
text "Setup is inspecting your computer's hardware configuration..." will
appear at the top. Press the <F6> key within two seconds to interrupt this
process.
3. Follow the instructions on the screen until you are asked to specify a SCSI
driver. At that point, insert Driver Disk 1 into your local floppy-disk drive, and
press <ENTER>.
4. Select the "Initio INI-A100U2W SCSI Host Adapter" and press <ENTER>.
The Windows NT Adapter driver is now installed. The on-screen instructions will
continue for a complete installation of Windows NT. Refer to your Windows NT
System Administrator's Guide for the rest of the operating-system installation
procedure.
58
W
NT I
INDOWS
NSTALLATION
NOTE
Advertisement
Table of Contents
