Table of Contents
Advertisement
When you see this prompt, you can either:
• Wait five seconds or press [ESC] to continue with the boot process;
• Press [CTRL] [B] to boot from a SCSI CD-ROM attached to the Adapter
(if this capability has been firmware-enabled—see Section 4.6.5); or
• Press [CTRL] [I] to start the Utility.
The Utility's Main Menu (shown, with Device Setup selected, in Figure 4-7
below) appears directly as soon as you run the Utility. When it does, you will
have five main options to choose from:
Scan Bus
Selecting any of these options (using the right- and left-arrow keys) will cause the
Utility to display a corresponding submenu; see Sections 4.6.2 through 4.6.6
respectively. You can also exit the utility at any time by pressing <ESC> (Escape);
see Section 4.6.7.
Figure 4-7. The SmartSCSI Device Setup menu screen.
Device Setup
↓→↑←
CHAPTER 4: Installation and Configuration
Adapter Setup
Utility
BIOS Setup
Disk
31
Advertisement
Table of Contents
