Table of Contents
Advertisement
11. Highlight "Save parameters and continue" and press <ENTER>.
12. This will load the Adapter's HAM driver. Follow the on-screen directions to
complete the Novell NetWare installation. (Even if you already have an an
updated version of the HAM driver to install, we recommend that, instead of
trying to load it now, you wait until you finish the initial system installation
and then load it using the NetWare Install utility—see the next two sections.)
5.5.2 A
N
DDING THE
Take these steps to install the Ultra2 LVD SCSI Host Adapter drivers in an existing
NetWare system:
1. To start, you will need to change to the directory where the server software is
located and reinitialize it; for example, you might type "CD \ NWSERVER"
and press <ENTER> to change the directory, then type "SERVER" and press
<ENTER> to run the software.
2. At the NetWare prompt, type "LOAD INSTALL", then press <ENTER>.
3. Select "Driver Options" from the window that appears: Use the up- and down-
arrow keys to move the highlight to it, then press <ENTER>. Select
"Configure disk and storage device drivers" from the next window the same
way. And when the window after that appears, select "Discover and load
additional drivers" the same way.
4. Press <ENTER> to see a list of currently available drivers.
5. Press <INS> (insert) to install a new driver (one that isn't on the list yet)
followed by <F3>.
6. Insert Driver Disk 1 in drive A:, then press <ENTER>. This completes loading
the Adapter driver.
W
D
ET
ARE
RIVER TO AN
CHAPTER 5: Driver Installation
E
N
W
XISTING
ET
ARE
S
YSTEM
63
Advertisement
Table of Contents
