Table of Contents
Advertisement
ULTRA2 LVD SCSI HOST ADAPTER
5.4.1 R
N
EGULAR
EW
These instructions will guide you through the installation of the Ultra2 LVD SCSI
Host Adapter's Windows NT driver while installing Windows NT 4.0 itself, either
from floppy diskettes or CD-ROM. The Windows NT driver will be found on Driver
Disk 1. It is important that the hardware has been installed successfully before
proceeding further.
1A. If you are installing Windows NT from floppy diskettes, locate the Windows NT Setup
Disk for Floppy Installation. Make a backup copy of this diskette before
installation.
1B. If you are installing Windows NT from a CD-ROM drive, locate the Windows NT
Setup Disk for CD-ROM Installation. Make a backup copy of this diskette
before installation.
2. Insert the backup Windows NT Setup Disk into drive A: and turn on your
computer.
3. Follow the instructions on the screen until you come to a window titled
"Windows NT Workstation Setup." Press "ENTER" to continue setting up
Windows NT, select "S" to skip mass-storage detection, and select "S" again to
configure additional SCSI adapters.
4. When prompted by the Windows NT installation program, scroll down the list
and select "Other (Requires Disk Provided by a Hardware Manufacturer)"
from the list of "Additional SCSI Adapters." Following the on-screen
instructions, remove the diskette in drive A and set it aside, then insert Driver
Disk 1 and press <ENTER>, then select "Initio INI-A100U2W SCSI Host
Adapter" and press <ENTER> again.
5. The Adapter's Windows NT driver is now installed. The on-screen instructions
will continue for a complete installation of Windows NT. Refer to your
Windows NT user's manual for the rest of the operating-system installation
procedure.
56
W
NT I
INDOWS
NSTALLATION
Advertisement
Table of Contents
