Table of Contents
Advertisement
5.4.2 N
W
EW
INDOWS
For computer systems installing or upgrading to Windows NT from a bootable CD,
these instructions will guide you through the Ultra2 LVD SCSI Host Adapter's
Windows NT driver installation. The Windows NT driver is on Driver Disk 1. It is
important that the hardware has been installed successfully before proceeding
further.
Even though Windows NT can itself be installed from a CD, you must
use a floppy drive on the local host computer to install the Adapter's
Windows NT driver on that computer.
1. Boot your system from a Windows NT CD.
2. When the nitial boot screen (a black and white screen priot to the blue
screen) shows the message, "Setup is inspecting your computer's hardware
configuration...", press the <F6> key within two seconds to interrupt this
process.
3. A setup screen will appear asking which drivers you want to use.
4. When prompted by the Windows NT installation program, scroll down the list
of "Additional SCSI Adapters" and select "Other (Requires Disk Provided by a
Hardware Manufacturer)".
5. Windows NT will prompt you to insert the disk. At that point, insert Driver
Disk 1 into your local floppy-disk drive, and press <ENTER>.
6. Select the "Initio INI-A100U2W SCSI Host Adapter" and press <ENTER>.
The Windows NT Adapter driver is now installed. The on-screen instructions will
continue for a complete installation of Windows NT.
NT I
NSTALLATION FROM A
CHAPTER 5: Driver Installation
B
CD
OOTABLE
NOTE
57
Advertisement
Table of Contents
