Table of Contents
Advertisement
ULTRA2 LVD SCSI HOST ADAPTER
5.2.4 N
W
EW
INDOWS
These instructions will guide you through the installation of the Ultra2 LVD SCSI
Host Adapter's Windows 95 driver while installing Windows 95b (OSR2) itself.
Windows 95b will be installed from either a CD-ROM or floppy diskettes. It is
important that the hardware and DOS 4.01 or higher have been installed
successfully before proceeding further. If you are installing from a SCSI CD-ROM
drive, it is important that the Adapter's ASPI driver and CD-ROM driver be
installed (see Section 5.1) before proceeding further.
1A. If you're installing from CD-ROM: Access the Windows 95b CD-ROM either from
the DOS prompt or from the Microsoft Windows 3.x File Manager. Execute
the SETUP.EXE program and follow the instructions on your screen.
1B. If you're installing from floppy diskette: Put Windows 95b Setup Disk 1 in your
floppy-disk drive and boot your system. Follow the instructions on your
screen.
2. Once a Windows 95 session is established, start from the desktop and use your
installed mouse or the appropriate keystrokes to select these items one after
the other (each item contains the next in sequence): "My Computer,"
"Control Panel," "System," "Device Manager" tab, "Other Devices" category,
"PCI-SCSI Bus Controller" subcategory.
3. In the "PCI SCSI Bus Controller Properties" window, select the "Driver" tab,
then select "Update Driver..."
4. Insert Driver Disk 1 into drive A:, then select "Yes" and click "Next."
Windows 95 will search for the driver.
5. Select "Other Location." Enter the pathname of the Windows 95 driver's
directory ("A:\WIN95") and select "OK".
6. Select "Finish." When the "Insert disk labeled INI-A100U2W Driver Disk 1"
window appears, select "OK".
7. A "Copying file" window will appear. Replace the highlighted directory
pathname with "A:\WIN95" and select "OK".
8. This completes installing the Adapter's device driver. Reboot the system to
activate the driver.
9. We highly recommend that you verify that your Windows 95 device driver has
been properly installed by starting at the desktop and selecting these items
one after the other (each item contains the next in sequence): "My
Computer," "Control Panel," "System," "Device Manager" tab, "SCSI
48
95
(OSR2) I
B
NSTALLATION
Advertisement
Table of Contents
