Table of Contents
Advertisement
ULTRA2 LVD SCSI HOST ADAPTER
5.5.1 N
N
W
EW
ET
ARE
Driver Disk 1 contains NetWare drivers for the Ultra2 LVD SCSI Host Adapter. In
most cases you will load the drivers during a new installation of NetWare from
CD-ROM. The driver is loaded during the NetWare Server Installation procedure.
The NetWare installation program will prompt you for the required parameters as
the installation procedure progresses. We highly recommend that you have a copy
of the Novell NetWare Installation and Upgrade Manual for reference.
1. At the MS-DOS prompt for CD-ROM installation, change to the volume or
directory where the installation files are located; for example, you might type
in D:\<ENTER>.
2. Type INSTALL <ENTER> to initialize the installation routine.
3. One after another, select these things (pressing <ENTER> after each one):
• the installation language,
• "Netware Server Installation,"
• the product type, and
• the installation type.
4. Enter the server name when you are prompted to do so, then press <ENTER>
again. At this point the boot files will be copied to your hard drive.
5. After the files are finished being copied, this message might be displayed:
Install found the following hardware but found
more than one driver supporting this hardware
PCI.XXXX.XXXX.XXXX.XXXX.XX
Press <Enter> for a list of drivers to choose
Press <F3> to continue without selecting
Press <F3> to continue. If this message reappears, keep pressing <F3> until it
goes away.
6. At the "Server Driver Summary Screen," choose "Select/Edit Disk or LAN
Drivers." Highlight "Disk CD-ROM Drivers" and press <ENTER>.
7. Press <INS> (insert) followed by <F3>.
8. Insert Driver Disk 1 in drive A: and press <ENTER>.
9. Highlight "INIA100.HAM" and press <ENTER>.
10. Highlight "Select/Modify Driver Parameters". Type the slot number in at the
window that appears and press <F10>.
62
4.
5.0 I
XX OR
NSTALLATION
Advertisement
Table of Contents
