Cisco WS-C3550-12G Software Configuration Manual page 76

Menus and Toolbar
•
•
Table 3-10 Menu Bar
Menu-Bar Options
CMS
Page Setup
Print Preview
Print
Guide Mode/Expert Mode
2
Preferences
Administration
2
IP Addresses
2
SNMP
2
System Time
2
HTTP Port
2
Console Baud Rate
2
MAC Addresses
2
ARP
1
Save Configuration
1
Software Upgrade
1
System Reload
Catalyst 3550 Multilayer Switch Software Configuration Guide
3-16
If your cluster has these member switches running earlier software releases and if you have
read-only access to these member switches, some configuration windows for those switches display
incomplete information:
Catalyst 2900 XL or Catalyst 3500 XL member switches running Cisco IOS
–
Release 12.0(5)WC2 or earlier
Catalyst 2950 member switches running Cisco IOS Release 12.0(5)WC2 or earlier
–
Catalyst 3550 member switches running Cisco IOS Release 12.1(6)EA1 or earlier
–
For more information about this limitation, refer to the Catalyst 3550 release notes.
These switches do not support CMS access modes:
– Catalyst 1900 and Catalyst 2820
Catalyst 2900 XL switches with 4-MB CPU DRAM
–
If these switches are in a cluster that is using CMS access levels, these switches appear as
unavailable devices and cannot be configured from CMS.
Task
Set default document printer properties to be used when printing from CMS.
View the way the CMS window or help file will appear when printed.
Print a CMS window or help file.
1
Select which interaction mode to use when you select a configuration option.
Set CMS display properties, such as polling intervals, the default views to open at startup,
and the color of administratively shutdown ports.
Configure IP information for a switch.
Enable and disable Simple Network Management Protocol (SNMP), enter community
strings, and configure end stations as trap managers.
Configure the system time or configure the Network Time Protocol (NTP).
Configure the Hypertext Transfer Protocol (HTTP) port.
Change the baud rate for the switch console port.
Enter dynamic, secure, and static addresses in a switch address table. You can also define
the forwarding behavior of static addresses.
Display the device Address Resolution Protocol (ARP) table, and configure the ARP
cache timeout setting.
Save the configuration for the cluster or switch to Flash memory.
Upgrade the software for the cluster or a switch.
Reboot the switch with the latest installed software.
Chapter 3 Getting Started with CMS
78-11194-03