Cisco WS-C3550-12G Software Configuration Manual page 231

Chapter 8 Configuring Interface Characteristics
Table 8-2 Show Commands for Interfaces (continued)
Command
show running-config
show version
This example shows how to display the status and configuration of Gigabit Ethernet interface 0/2:
Switch# show interfaces gigabitethernet0/2
GigabitEthernet0/2 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 0002.4b29.4400 (bia 0002.4b29.4400)
Internet address is 192.20.135.21/24
MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
This example shows how to display the status of all interfaces:
Switch# show interfaces status
Port
Gi0/1
Gi0/2
Gi0/3
Gi0/4
Gi0/5
Gi0/6
Gi0/7
Gi0/8
Gi0/9
Gi0/10
Gi0/11
Gi0/12
78-11194-03
reliability 255/255, txload 1/255, rxload 1/255
89245 packets input, 8451658 bytes, 0 no buffer
Received 81551 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
60387 packets output, 5984015 bytes, 0 underruns
0 output errors, 0 collisions, 16 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Name Status
CubeA connected
CubeE notconnect
CubeF disabled
CubeG notconnect
CubeH notconnect
CubeI notconnect
CubeJ connected
CubeK notconnect
CubeL disabled
CubeB notconnect
CubeC notconnect
CubeD notconnect
Purpose
Display the running configuration in RAM.
Display the hardware configuration, software version, the names and
sources of configuration files, and the boot images.
Vlan Duplex
1 a-full
1 auto
1 auto
1 auto
routed auto
routed auto
1 a-full
1 auto
1 auto
routed auto
1 auto
1 auto
Catalyst 3550 Multilayer Switch Software Configuration Guide
Monitoring and Maintaining the Layer 2 Interface
Speed Type
a-100 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto 10/100/1000BaseTX
a-100 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto 10/100/1000BaseTX
auto unknown
auto unknown
8-19