Eigrp Interface Mode Commands - Cisco WS-C3550-12G Software Configuration Manual

Chapter 22 Configuring IP Unicast Routing
Command
Step 6 offset list [access-list number | name] {in | out}
offset [type number]
Step 7
no auto-summary
Step 8
ip summary-address eigrp
autonomous-system-number address mask
Step 9
end
Step 10 show ip protocols
Step 11 copy running-config startup-config
Use the no forms of these commands to disable the feature or return the setting to the default value.
This is an example of output from the show ip protocols privileged EXEC command for EIGRP.
Switch# show ip protocols
<output truncated>
Routing Protocol is "eigrp 1"
Outgoing update filter list for all interfaces is
Incoming update filter list for all interfaces is
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 1, igrp 1
Automatic network summarization is in effect
Maximum path: 4
Routing for Networks:
Routing Information Sources:
Distance: internal 90 external 170

EIGRP Interface Mode Commands

Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps:
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 ip bandwidth-percent eigrp percent
Step 4 ip summary-address eigrp
autonomous-system-number address mask
78-11194-03
172.20.0.0
Gateway Distance
Purpose
(Optional) Apply an offset list to routing metrics to increase
incoming and outgoing metrics to routes learned through EIGRP.
You can limit the offset list with an access list or an interface.
(Optional) Disable automatic summarization of subnet routes into
network-level routes.
(Optional) Configure a summary aggregate.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Last Update
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3
interface to configure.
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
Catalyst 3550 Multilayer Switch Software Configuration Guide
Configuring EIGRP
22-49