802.1Q Configuration Considerations; Default Layer 2 Ethernet Interface Vlan Configuration - Cisco WS-C3550-12G Software Configuration Manual

Multilayer switch
Hide thumbs Also See for WS-C3550-12G:
Table of Contents

Advertisement

Understanding VLAN Trunks

802.1Q Configuration Considerations

802.1Q trunks impose these limitations on the trunking strategy for a network:

Default Layer 2 Ethernet Interface VLAN Configuration

Table 9-8
Table 9-8
Feature
Interface mode
Trunk encapsulation
Allowed VLAN range
VLAN range eligible for pruning
Default VLAN (for access ports)
Native VLAN (for 802.1Q trunks)
Catalyst 3550 Multilayer Switch Software Configuration Guide
9-24
In a network of Cisco switches connected through 802.1Q trunks, the switches maintain one instance
of spanning tree for each VLAN allowed on the trunks. Non-Cisco devices might support one
spanning-tree instance for all VLANs.
When you connect a Cisco switch to a non-Cisco device through an 802.1Q trunk, the Cisco switch
combines the spanning-tree instance of the VLAN of the trunk with the spanning-tree instance of
the non-Cisco 802.1Q switch. However, spanning-tree information for each VLAN is maintained by
Cisco switches separated by a cloud of non-Cisco 802.1Q switches. The non-Cisco 802.1Q cloud
separating the Cisco switches is treated as a single trunk link between the switches.
Make sure the native VLAN for an 802.1Q trunk is the same on both ends of the trunk link. If the
native VLAN on one end of the trunk is different from the native VLAN on the other end,
spanning-tree loops might result.
Disabling STP on the native VLAN of an 802.1Q trunk without disabling STP on every VLAN in
the network can potentially cause spanning-tree loops. We recommend that you leave STP enabled
on the native VLAN of an 802.1Q trunk or disable STP on every VLAN in the network. Make sure
your network is loop-free before disabling STP.
shows the default Layer 2 Ethernet interface VLAN configuration.
Default Layer 2 Ethernet Interface VLAN Configuration
Chapter 9
Default Setting
switchport mode dynamic desirable
switchport trunk encapsulation negotiate
VLANs 1–1005
VLANs 2–1001
VLAN 1
VLAN 1
Creating and Maintaining VLANs
78-11194-03

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3550

Table of Contents