Enabling A Command Switch - Cisco WS-C3550-12G Software Configuration Manual

Chapter 5 Clustering Switches

Enabling a Command Switch

The switch you designate to be the command switch must meet the requirements described in the
"Command Switch Characteristics" section on page
page
Note •
•
•
•
You can enable a command switch, name the cluster, and assign an IP address and a password to the
command switch when you run the setup program during initial switch setup. For information about
using the setup program, refer to the release notes.
If you did not enable a command switch during initial switch setup, launch Device Manager from a
command-capable switch, and select Cluster > Create Cluster. Enter a cluster number (the default is 0),
and use up to 31 characters to name the cluster
switch, you can use the cluster enable global configuration command.
Figure 5-9
78-11194-03
5-4, and the release notes.
We strongly recommend that the highest-end, command-capable switch in the cluster be the
command switch:
If your switch cluster has a Catalyst 3550 switch, that switch should be the command switch.
If your switch cluster has Catalyst 2900 XL, Catalyst 2950, and Catalyst 3500 XL switches, the
Catalyst 2950 should be the command switch.
If your switch cluster has Catalyst 1900, Catalyst 2820, Catalyst 2900 XL, and Catalyst 3500 XL
switches, either the Catalyst 2900 XL or Catalyst 3500 XL should be the command switch.
Create Cluster Window
C3550-12T
5-2, "Planning a Switch Cluster" section on
(Figure 5-9). Instead of using CMS to enable a command
Enter up to 31 characters
to name the cluster.
Catalyst 3550 Multilayer Switch Software Configuration Guide
Creating a Switch Cluster
5-19