Cisco WS-C3550-12G Software Configuration Manual page 422

Configuring Router ACLs
Command
or access-list access-list-number
{deny | permit} protocol any any
[precedence precedence] [tos tos]
[fragments] [log] [log-input]
[time-range time-range-name]
[dscp dscp]
or access-list access-list-number
{deny | permit} protocol
host source host destination
[precedence precedence] [tos tos]
[fragments] [log] [log-input]
[time-range time-range-name]
[dscp dscp]
Step 2b
access-list access-list-number
{deny | permit} tcp source
source-wildcard [operator [port]]
destination destination-wildcard
[operator [port]] [established]
[precedence precedence] [tos tos]
[fragments] [log] [log-input]
[time-range time-range-name]
[dscp dscp] [flag]
Step 2c access-list access-list-number
{deny | permit} udp
source source-wildcard [operator
[port]] destination
destination-wildcard [operator
[port]] [precedence precedence]
[tos tos] [fragments] [log]
[log-input] [time-range
time-range-name] [dscp dscp]
Catalyst 3550 Multilayer Switch Software Configuration Guide
19-12
Purpose
In access-list configuration mode, define an extended IP access list using an
abbreviation for a source and source wildcard of 0.0.0.0 255.255.255.255 and
an abbreviation for a destination and destination wildcard of 0.0.0.0
255.255.255.255.
You can use the any keyword in place of source and destination address and
wildcard.
Define an extended IP access list using an abbreviation for a source and source
wildcard of source 0.0.0.0 and an abbreviation for a destination and destination
wildcard of destination 0.0.0.0.
You can use the host keyword in place of source and destination wildcard
or mask.
(Optional) Define an extended TCP access list and the access conditions.
Enter tcp for Transmission Control Protocol.
The parameters are the same as those described in Step 2a with these exceptions:
(Optional) Enter an operator and port to compare source (if positioned after
source source-wildcard) or destination (if positioned after destination
destination-wildcard) port. Possible operators include eq (equal), gt (greater
than), lt (less than), neq (not equal), and range (inclusive range). Operators
require a port number (range requires two port numbers separated by a space).
Enter the port number as a decimal number (from 0 to 65535) or the name of a
TCP port. To see TCP port names, use the ? or refer to "Configuring IP
Services" section of Cisco IOS IP and IP Routing Command Reference for IOS
Release 12.1. Use only TCP port numbers or names when filtering TCP.
The additional optional keywords have these meanings:
established—Enter to match an established connection. This has the same
•
function as matching on the ack or rst flag.
flag—Enter one of these flags to match by the specified TCP header bits:
•
ack (acknowledge), fin (finish), psh (push), rst (reset), syn (synchronize),
or urg (urgent).
(Optional) Define an extended UDP access list and the access conditions.
Enter udp for the User Datagram Protocol.
The UDP parameters are the same as those described for TCP except that
[operator [port]] port number or name must be a UDP port number or name, and
the flag and established parameters are not valid for UDP.
Chapter 19 Configuring Network Security with ACLs
78-11194-03