Configuring A Range Of Interfaces - Cisco WS-C3550-12G Software Configuration Manual

Chapter 8 Configuring Interface Characteristics
5 minute output rate 0 bits/sec, 0 packets/sec

Configuring a Range of Interfaces

You can use the interface range global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
Command
Step 1
configure terminal
Step 2 interface range {port-range | macro
macro_name}
Step 3
Step 4 end
Step 5
show interfaces [interface-id]
Step 6
copy running-config startup-config
When using the interface range global configuration command, note these guidelines:
•
78-11194-03
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Valid entries for port-range:
vlan vlan-ID - vlan-ID
–
– fastethernet slot/{first port} - {last port}, where slot is 0
– gigabitethernet slot/{first port} - {last port}, where slot is 0
– port-channel port-channel-number - port-channel-number, where port-channel-number is
from 1 to 64
Purpose
Enter global configuration mode.
Enter interface range configuration mode by entering the range of
interfaces (VLANs or physical ports) to be configured.
You can use the interface range command to configure up to five
•
port ranges or a previously defined macro.
The macro variable is explained in the
•
Interface Range Macros" section on page
Each comma-separated port-range must consist of the same port
•
type. You do not need to enter spaces before or after the comma.
When you define a range, the space between the first port and the
•
hyphen is required.
You can now use the normal configuration commands to apply the
configuration parameters to all interfaces in the range.
Return to privileged EXEC mode.
Verify the configuration of the interfaces in the range.
(Optional) Save your entries in the configuration file.
Catalyst 3550 Multilayer Switch Software Configuration Guide
Using the Interface Command
"Configuring and Using
8-11.
8-9