Power-Supply Modules - Cisco IE-3010-16S-8PC Hardware Installation Manual

Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your switch ships
with at least one installed power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable.
For translations of the safety warnings in this chapter, see the Regulatory Compliance and Safety
Information for the Cisco IE 3010 Switch on the documentation CD and also on Cisco.com.
•
•
•
•
•
•

Power-Supply Modules

For information on the power-supply modules, see the
Table 3-1
Model
PWR-RGD-LOW-DC/IA
PWR-RGD-AC-DC/IA
78-19581-01
Power-Supply Modules, page 3-1
Installation Guidelines, page 3-3
Grounding the Switch, page 3-5
Installing the Power-Supply Module in the Switch, page 3-7
Wiring the Power Source, page 3-8
Removing the Power-Supply Module, page 3-13
Power-Supply Modules
Description
Low-voltage DC. For voltage information, see
High-voltage AC or DC. For voltage information, see
page
C H A P T E R
"Power Supply Features" section on page
A-4.
Cisco IE 3010 Switch Hardware Installation Guide
3
1-14.
Table A-6 on page A-4.
Table A-5 on
3-1