Appendix; Configuring The Switch With The Cli Setup Program; Accessing The Cli Through The Console Port; Rj-45 Console Port - Cisco IE-3010-16S-8PC Hardware Installation Manual

Configuring the Switch with the CLI Setup
Program
This appendix provides a command-line interface (CLI) setup procedure for a standalone switch. To set
up the switch by using Express Setup, see the Cisco IE 3010 Switch Getting Started Guide. Before
connecting the switch to a power source, review the safety warnings in
and

Accessing the CLI Through the Console Port

You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access
the CLI:
•
•

RJ-45 Console Port

Step 1 Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. Connect the other end of the
cable to the switch console port.
Step 2 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC
application such as HyperTerminal or ProcommPlus, makes communication between the switch and
your PC or terminal possible.
78-19581-01
Chapter 3, "Power Supply Installation."
RJ-45 Console Port
USB Console Port
A P P E N D I X
Chapter 2, "Switch Installation,"
Cisco IE 3010 Switch Hardware Installation Guide
C
C-1