Table of Contents
Advertisement
Power-Supply Module Installation
Installing a Power-Supply Module
This procedure is for installing a power-supply module in the PSU1 or PSU2 slot.
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Equipment installation must comply with local and national electrical codes.
Caution
Equipment That You Need
•
•
Note
•
•
•
•
•
•
•
•
Cisco IE 3010 Switch Hardware Installation Guide
3-4
Ratcheting torque flathead screwdriver that exerts up to 15-inch pound (in-lb) of torque
Ring, spade, or flanged spade terminal (terminals should be insulated)
–
Ring terminal (such as Tyco part number 2-34158-1 for 16–14 AWG or 2-34852-1 for 12–10
AWG wire)
Spade terminal (such as Tyco part number 54367-2 for 16–14 AWG wire)
–
–
Flanged spade terminal (such as Tyco part number 2-324165-1 for 16–14 AWG wire or
1-324581-1 for 12–10 AWG wire)
For IP-30 compliance:
Use the 16-14 AWG wire and appropriate terminals for the AC or high-voltage DC power supply
Use the12-10 AWG wire and appropriate terminals for the low-voltage DC power supply
Crimping tool (such as Thomas & Bett part number WT2000, ERG-2001)
6-gauge copper ground wire (such as Belden part number 9906)
12-AWG wire (minimum) for the low-voltage power-supply module and 16-AWG (minimum) wire
for the high-voltage power-supply module
For power source connections, use wires rated for at least 194°F (90°C).
UL- and CSA-rated style 1007 or 1569 twisted-pair copper wire (such as Belden part number 9318)
Wire-stripping tools for stripping 6-, 10-, 12-, 14-, and 16-gauge wires.
Number-2 Phillips screwdriver
Flat-blade screwdriver
Chapter 3
Power Supply Installation
78-19581-01
Advertisement
Table of Contents
