Table of Contents
Advertisement
Chapter 3
Power Supply Installation
Installing the Power-Supply Module in the Switch
We recommend that power be off at the AC or DC circuits. Locate the circuit breakers, turn them OFF,
Step 1
and tape them in the OFF position.
Note
Use a Phillips screwdriver to loosen the two captive screws of the blank power-supply module and gently
Step 2
pull it out. See
Figure 3-6
C i sco I E
301 0
Sw i t ch Ser
i es
Figure 3-7
C i sco C onn
Sw i tch 250
Insert the power-supply module into the slot, and gently push it in. See
Step 3
module should be flush with the switch.
78-19581-01
If the power is not off at the AC or DC circuit breaker, do not touch the power-input terminal.
Figure 3-6
and
Loosen the Screws on the Power Supply Blank
Remove the Power Supply Blank
ect ed G ri
d
0 Ser i es
Figure
3-7.
Cisco IE 3010 Switch Hardware Installation Guide
Power-Supply Module Installation
Figure
3-8. The power-supply
3-7
Advertisement
Table of Contents
