Avaya PARTNER Advanced Communications System System Planner Manual page 28

®
PARTNER Advanced Communications System
Form E: Instructions for System Configuration: Default Settings
Q 1: L E
UESTION INES PER XTENSION
For the PARTNER ACS processor or 308EC module, the default setting assigns 3 lines to each extension.
For the 206 module, the default setting assigns 2 lines to each extension.
For the 400 module, the default setting assigns 4 lines to each extension.
For the 1600 DSL module, the default setting assigns 16 lines to each extension (R4).
For the 012E module, the default setting assigns 0 lines to each extension (R5).
For the T1 module, the default setting assigns 16 lines to each extension (R6).
Q 2: S P
UESTION YSTEM ASSWORD
The default setting is "No Password." If a password is desired, this password will be required to override dialing restrictions and to turn Night
Service on and off.
Q 4: R B
UESTION INGS EFORE THE
By default, a transferred call rings 4 times before it goes to the transfer return extension. If preferred setting is different than 4, write in the
preferred number of rings. (Options are 1 through 9).
Q 8: P . K :
UESTION OOL VS EY
Most PARTNER customers operate their lines in KEY mode. This mode works well for customers with a minimum number of incoming lines
(that is, less than 5). In Key mode, the selected lines will show up as distinct buttons on each user's phone. The user can view the buttons to
determine which lines are in use, and which are open before initiating a call. In HYBRID mode, some of the lines are pooled together. This
pooling is transparent to the user. For instance if 3 lines are pooled under the company's main number, up to 3 users can select the button
marked with that number before the pool is busy. This mode is appropriate for companies requiring a lot of lines.
If you wrote POOL in this box, see Form F5. Pooling is only available for PARTNER ACS R2.0 or later. By default, the system is configured for
KEY mode.
Q 9: H R T
UESTION OLD EMINDER ONE
By default, the PARTNER system will provide a reminder tone for a call on hold for 60 seconds. If the preferred setting is different from 60
seconds, circle the setting you want to use. (If you do not want the PARTNER system to provide Hold Reminder Tone, select "Not Active.")
Q 10: T1 L
UESTION INE
If you will use a T1 line with the PARTNER system, circle "YES," and see the PARTNER ACS T1 Module Planning Forms (Forms G1, G2, G3,
and G4.) A T1 line is only available for PARTNER ACS R6.0.
Form E: Instructions for System Configuration: Default Settings
20
:
:
T R :
RANSFER ETURNS
:
0