Lucent Technologies MERLIN LEGEND Release 7.0 Pocket Reference page 123

MERLIN LEGEND Communications System Release 7.0
Pocket Reference 555-670-116
Reference Documents
Maintenance Error Codes
Error
Code Description
6C06 DS1 REMOTE MULTIFRAME:
Far end of network interface is
experiencing loss of multiframe;
service on link has been lost.
6C07 DS1 MAJOR ALARM:
Average bit error rate exceeds
10E-3; service on link has been
lost.
6C08 DS1 MINOR ALARM:
Average bit error rate exceeds
10E-6.
6C09 DS1 MISFRAME ALARM:
Misframe count reached 18.
6C0A DS1 SLIP ALARM:
Slip count reached 88.
6C0B HARDWARE INOPERATIVE:
Hardware not operating properly.
If this is the only 100D module or
800 NI-BRI module, or if this is the
designated clock module, its tdm
bus clock generator was not
activated.
6C0C BRI LOSS OF SYNC:
Service on link has been lost.
6C0D BRI SLIPS > 88:
Slip count > 88. Service on link is
still operative.
6C0E BRI NET REQUESTED
CCRCs:
Outgoing signal to the network
does not have valid framing
information. Service on link is still
operative.
6C0F BRI NET DEACTIVATE:
Layer 1 of the link is down. Service
on link has been lost.
Technical Addendum
—Continued
Action
Usually no action. Check T1
facility. If problem persists,
contact NSAC Tier III.
Usually no action. Check T1
facility. If problem persists,
contact NSAC Tier III.
Maintenance Slot
Error Events
Current hr
Usually no action. Check T1
facility. If problem persists,
contact NSAC Tier III.
Maintenance Slot
Error Events
Current hr
Usually no action. Check T1
facility. If problem persists,
contact NSAC Tier III.
Maintenance Slot
Error Events
Current hr
Usually no action. Check T1
facility. If problem persists,
contact NSAC Tier III.
Maintenance Slot
Error Events
Current hr
A Busy-Out/Restore or Reset/
Restore may clear problem. If
problem persists, contact NSAC
Tier III.
Usually none; check BRI facility.
If problem persists, contact
NSAC Tier III.
Usually none; check BRI facility.
If problem persists, contact
NSAC Tier III.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
Issue 1
April 1999
117