Upgrading Software Using The Boot Menu - 3Com 7700R - Switch Starter Kit Installation Manual

Upgrading Software
Using The BOOT Menu
<SW7700>boot boot-loader sw7700003.app
The specified file will be booted next time!
<SW7700>reboot
This will reboot Switch. Continue? [Y/N] y
For more detailed descriptions of the setup and procedures for upgrading
software, see the remaining sections in this chapter.
To perform this procedure, you must have a network connection to the
management port on the Switch 7700 Fabric module.
After powering on the Switch 7700, the BootROM program runs automatically.
The terminal displays the following information:
Starting......
RAM Line....OK
System is booting................
*
• SW 7700 BOOTROM, Version 4.00
*
Copyright© 2001-2005 by 3Com Corporation, Inc.
Creation date
CPU type
CPU Clock Speed : 200MHz
BUS Clock Speed : 66MHz
Memory Size
SW 7700 main board self testing...............................
60X_SDRAM Data lines Selftest.............................OK!
60X_SDRAM Address lines Selftest..........................OK!
60X_SDRAM fast selftest...................................OK!
LOCAL_SDRAM Data lines Selftest...........................OK!
LOCAL_SDRAM Address lines Selftest........................OK!
LOCAL_SDRAM fast selftest.................................OK!
Please check leds................ .....Led selftest finished!
Switch chip selftest......................................OK!
CPLD selftest.............................................OK!
Press Ctrl-B to enter Boot Menu...
1 Press Ctrl+B. The system displays:
Initialize flash file system. Please wait!
Password :
To access the BOOT Menu, press Ctrl+B during the five seconds that "Press Ctrl-B
to enter Boot Menu..." displays. After five seconds, the system begins program
decompression. If you want to access the BOOT Menu after this, you must reboot
the switch.
2 Enter the BootROM password. After entering the correct password (no password
is set for the switch by default), the system will access the BOOT Menu:
CAUTION: While using the switch, keep in mind the modified BOOTROM
password.
Boot Menu
1: Download application file to flash
*
: May 26 2002, 10:23:31
: MPC8260
: 128MB
Upgrading Software 49
*
*