Upgrading Software With Ftp - 3Com 7700R - Switch Starter Kit Installation Manual

48 C 4: M
HAPTER AINTAINING
Upgrading Software
with FTP
S
OFTWARE
To upgrade an 8-slot Switch 7700 with FTP:
1 Upgrade the Fabric in Slot0 using the procedure in Upgrading Software with FTP.
Do not issue the
reboot
2 Execute the
slave switchover
becomes the primary Fabric.
3 Repeat Step 1 for Slot1.
4 Issue the command and enter Y at the reboot prompt so the system
reboot
reboots.
As the system reboots, the Fabric in Slot0 will return to primary status.
In the following examples, the IP address of the local computer is 10.10.110.1 and
the image is SW7700003.app. Actual IP addresses and filenames will depend on
your system and software versions.
Use the following procedure to upgrade software with FTP:
1 Log in to the system with super-user privileges.
2 From the SW7700 command line, transfer the file from the FTP server to the
system, using the
ftp
3 Specify the file to boot the system from, using the
4 Reboot the system, using the
The following example illustrates this procedure:
<SW7700>su
Password:
Now user privilege is 3 level, and just commands which level is
equal to or less than this level can be used.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
<SW7700>ftp 10.10.110.1
Trying ...
Press CTRL+K to abort
Connected.
220 3Com 3CDaemon FTP Server Version 2.0
User(none):anonymous
331 User name ok, need password
Password: xxxxxxx
230 User logged in
[ftp]bin
200 Type set to I.
[ftp]get sw7700003.app
200 PORT command successful.
150 File status OK ; about to open data connection
226 Closing data connection; File transfer successful.
FTP: 3794803 byte(s) received in 130.480 second(s)
29.08Kbyte(s)/sec.
[ftp]quit
221 Service closing control connection
command.
command on Slot0 so that the Fabric in Slot1
command.
command.
reboot
command.
boot