Avaya PARTNER Quick Reference Manual page 76

6 Maintaining Your System
For a 2-slot carrier configuration, do the following:
4
Remove the long screw at the bottom of the modules.
a
Remove the screws that attach the carrier to the modules.
b
Pull the carrier to the right to remove it.
c
Slide the top module to the left to disengage its interlocking mounting
d
tracks from the processor module.
If you are replacing the processor module, go to Step e. If you are
replacing the top module, continue with Step g.
Remove the screw at the top of the processor module, and remove the
e
module from the wall.
Mount the new PARTNER ACS processor module by following the
f
instructions in
2-Slot Carrier" on page 8
Module" on page
Mount or remount the top module by following the steps in
g
"Wall-Mounting a Stand-Alone Processor Module and a 2-Slot Carrier"
on page
Connect the line and extension cords one at a time, making sure to place
5
the correct cords into their corresponding jacks on the new module. (See
"Connecting Lines and Extensions" on page
Reconnect the power cord.
6
CAUTION:
The power cord should hang straight down from the connector, flush
against the plastic case. Do not install the power cord at an angle to
the case or with a loop in it.
66 Replacing Modules
"Wall-Mounting a Stand-Alone Processor Module and a
12.
8.
and "Inserting Batteries in the Processor
16.)
Quick Reference Guide