Avaya PARTNER Quick Reference Manual page 31

Quick Reference Guide
Programming Overlays
To do System Programming, you place a Programming Overlay over the dialpad
of the system display telephone at extension 10 or 11. (Overlays are provided
with the system documentation.)
You use the following special buttons while programming:
N
•
programming procedures. You can use these buttons to select a procedure.
(If a procedure instructs you to press
these buttons one after the other enables you to repeat the current
programming procedure.)
n
• and
parameters. A parameter is typically an outside line, a pool, an extension,
or a telephone list entry.
D
• and
These buttons work only for fixed data, such as a line or extension number.
They do not work for variable data such as date, time, password, telephone
numbers, or doorphone assignments.
r
• returns the current setting to the factory setting. When you are
programming Line Assignment (#301), pressing
an extension; when you are programming Pool Extension Assignment
(#314), pressing
e
• ends an entry of variable length, such as a telephone number in an
Allowed Phone Number List.
s
•
c
•
customize individual telephones centrally from extension 10 or 11).
f
• , when followed by
w
• enters a "wildcard" (a character that matches any digit dialed) in
telephone numbers in Allowed Phone Number Lists (#407), Disallowed
Phone Number Lists (#404), and the Forced Account Code List (#409).
P
and
p
cycle forward and backward through a procedure's
d
cycle forward and backward through the valid entries.
r
removes pools from an extension.
starts the System Programming process.
starts the Centralized Telephone Programming process (to
00
cycle forward and backward through the
N
, enters or exits programming mode.
System Programming Basics
3 Setting Up Your System
P
+
r
removes lines from
, pressing
21