Avaya PARTNER Quick Reference Manual page 34

3 Setting Up Your System
Programming Mode
When you are ready to program a system or telephone feature, you must enter
programming mode. Follow these steps to enter programming mode.
Place the Programming Overlay over the dialpad of the system display
1
telephone at extension 10 or 11.
To enter programming mode, press
2
s
Press
3
s
Press
4
Specify a programming procedure in one of two ways:
5
• Direct Method: Dial the code for that procedure. System Programming
procedures in this guide are identified by a # and a three-digit code (for
example, System Date is #101). This method is best when you are using
only a few procedures during a programming session and you know the
codes.
• Cycle Method: Cycle through the procedures in numerical order. Press
N
the programming procedures. This method is best when you are using
multiple procedures during a programming session, or if you do not know
the codes.
To exit programming mode, you can press
6
handset and then place it back in the cradle.
Changing Programming Type
When you are in programming mode, you can move between System
Programming and Centralized Telephone Programming. To change to
Centralized Telephone Programming when you are in System Programming,
c
press
Centralized Telephone Programming, press
24 System Programming Basics
.
again.
P
and
. To move back to System Programming when you are in
f00
.
to cycle forward and backward through
f00
c
Quick Reference Guide
. Or you can lift the
s
, then .