Aligning The Top Of The Finisher - Lexmark C920 Service Manual

2.
Rotate the rear adjustment knobs to equally align the top and bottom of the finisher with the printer.
•
To move the top of the finisher closer to the printer, rotate the adjustment knobs clockwise.
•
To move the top of the finisher away from the printer, rotate the adjustment knobs counterclockwise.
3.
Roll the finisher toward the printer until the finisher locks to the docking plate pins. You hear a click when
the finisher locks into position.

Aligning the top of the finisher

Note: Anytime you move the printer or finisher, recheck the printer and finisher top alignment.
Follow these instructions if the alignment marks on top of the finisher are not aligned with the edges of the cover
on the side of the printer.
1.
Loosen the guide rail thumbscrews.
If you made previous adjustments, the thumbscrews are already loose.
2.
Rotate the adjustment knobs as needed to raise or lower the side of the finisher.
•
To raise the finisher, rotate the adjustment knobs clockwise.
•
To lower the finisher, rotate the adjustment knobs counterclockwise.
3.
Tighten the guide rail thumbscrews.
5056-XXX
3-63
Diagnostic aids