5.
Secure the drive with a screw. The screw hole is located on the side of
the housing.
6.
Connect the power cable and signal cables to the external device.
5.1.2
To remove a 3.5-inch storage device:
1.
Open the front panel door and remove the left panel. See section 4 for
more information on opening the housing panels.
2.
Disconnect the power and signal cable.
3.
Detached the external device by removing the screw located on the side
and then gently pull out the device.
4.
Remove the four screws and detach the 3.5-inch from the drive guide.
18
Installation Guide