Table of Contents
Advertisement
Installing and removing storage
devices
The system supports 3.5-inch and 5.25-inch internal storage devices.
The system comes pre-installed with a floppy drive and a CD-ROM
drive. The empty 5.25-inch half-height bays allow you to install
additional drives such as another CD-ROM drive or a tape drive.
To install a 5.25-inch storage device
Note: If you are installing a new drive in an empty drive bay, skip
steps 2 to 4.
1
Observe the ESD precautions and pre-installation procedures
described on page 41.
2
Disconnect the power and IDE cables from the old drive.
3
Lift the plastic tab that secures the drive in the bay (1) and gently
pull it from the chassis (2).
45
Advertisement
Table of Contents
