Floppy Drive B; Ide Primary Channel Master; Ide Primary Channel Slave; Total Memory - Acer Altos 11000 System User Manual

3.2.7

Floppy Drive B

This parameter specifies the system' s current floppy drive B settings.
For information on how to configure the floppy drives, see section
3.4.1.
3.2.8

IDE Primary Channel Master

This parameter specifies the current configuration of the IDE device
connected to the master port of the primary IDE channel. For
information on how to configure IDE devices, see section 3.4.2.
3.2.9

IDE Primary Channel Slave

This parameter specifies the current configuration of the IDE device
connected to the slave port of the primary IDE channel. For
information on how to configure IDE devices, see section 3.4.2.
3.2.10

Total Memory

This parameter specifies the total system memory. The memory size
is automatically detected by BIOS during the POST (Power-On Self
Test). If you install additional memory, the system automatically
adjusts this parameter to display the new memory size.
1st Bank/2nd Bank/3rd Bank/4th Bank
This parameter indicates the type of DRAM installed in the DIMM
sockets. The setting indicates that there is no DRAM installed.
None
For the location of the DIMM sockets, refer to Figure 2-1.
3.2.11

Serial Port 1

This parameter indicates the serial port 1 address and IRQ setting.
BIOS Utility 3-7